Yjq

Figure 6 Detection of charger generation of charger synchronization pulses Figure 6 Detection of charger generation of charger synchronization pulses In case the main battery is fully discharged and the UEM subsequently is without power i.e. in NO_SUPPLYor BACKUP mode, the start-up charging circuitry is in control, giving the possibility to detect a charger and engage charging. Ifthe VBAT level is detected to be lower than the master reset voltage (vmstr-) the CHACON will charge the battery...

MIDP Java Loader

MIDP - Java file loader Ul component is used for copying some selected MidLet-files (*.jad and *.jar) or folders from PC file - system to the phones file-system (please do not copy single files, since a Midlet is only executable if the proper jar and jad files are available in one folder). Only one Java application could be in one folder. This dialog can also be used for saving some MidLet-files or folders from the phone to the PC file-system. The left side of the window represents the PC side....

Description Page No

Flash programming MCU boot Flash identifiers Firstword Second word Third word Fourth word Fifth Absolute maximum ratings (AMD Absolute maximum ratings (INTEL HW Interfaces Keypad interface LCD interface SIM interface Ostrich JTAG interface BT module interface SW interface BT102 BT202 flash programming HW interface Baseband - RF interface Digital signals Analogue signals Voltage supplies and references MBus FBus SIMand keypad Figure 1 NPL-1 Basebandblock Figure 2 UEM state Figure 3 LCD worst...

Imd

UEM state where UEM has no supply what so ever Main battery voltage Master Resetthreshold level (2.1 V 1.9 V) Backup battery threshold level (3.1 V 2.8 V) UEM state where UEM has backup voltage UEM state where regulators are enabled UEM power saving state controlled by UPP Signal from power on key. '1' key pressed. Figure 1 NPL-1 baseband block diagram Figure 1 NPL-1 baseband block diagram A draft block diagram is shown in Figure 1 NPL-1 baseband block diagram. The baseband module contains 2...