Info

Flash Loading Adapter FLA-5 0080178 Flash Security Box TDF-4 0770106 D15-D15 Cable AXS-5 0730091 (Included in FLA-5 sales pack) Printer Cable (Included in FPS-4 sales pack) 0730029 D9 - D9 Cable AXS-4 0730090 (Included in FPS-4 sales pack) Software protection key PKD-1 0750018 Service SW diskette 3.5 0774080 Travel Charger ACH-6E (Euro) 0270381 Travel Charger ACH-6U (USA Japan) 0270382 Travel Charger ACH-6X (UK) 0270380 AC Charger ACL-3E (part of FPS-4 kit) 0680015 4 External Antenna Cable...

Baseband

The baseband architecture is a combination ofthe HD945 and Santeri HD914 baseband architecture. The baseband differ from the HD945 phone in not having a slide and roller. The system specific MCU and DSP are integrated into one ASIC, called the MAD2WD1 Compared to MAD2PR1 from HD945 it holds the following changes Flexpool synthEna2X added to flexpool. The ARM on the part is able to run at 26MHz, a PLL is included to double the frequency. A new concept in this product is that only LCD, earpiece,...

Madwd

Automatic Frequency Control Automatic Gain Control Multifunction power management IC for DCT3 Charge Control Switch IC Mixed signal baseband IC for DCT3, includes RFI and PCM-CODEC, this version further supports PHS and Direct Conversion Control, Timing, Sleep mode and Interrupt module of MAD2WD1. This module takes care of a lot of basic control, e.g. the trigging of events at exact clock tic's as programmed in the registers of the CTSI. Digital Core Technology, third generation of...

Ccontint

SLEEPCLK (J112 C113) SYNTHPWR (J317) VB (J103 C105) VCORE (C155) VBB (J108 C147) VCOBBA (J109 C254) VBATTIR (L121) VBATTRF (L122) VBATTUI (L120) VREF (J117 C143) VREF_RX (R510) VSYN_1 (J106 C130) VSYN_2 (C133) VRX (J104 C136) VTX (J107 C142) VXO (J105 C141) VCP (J110 C157) V_IN (F101) VPP (C349) Always high level, only pulled down as long as powerkey is pressed. Power-Up-Reset signal from CCONT. When the voltages are stable, this line is on high level allowing the MAD to run (Masterreset). Chip...

RX Filter Calibration Automatic

This calibration is calibrating the Baseband filter inside Hagar, for this reason the calibration is not done in both bands. In the Select Function frame select RX Filter calibration (Automatic). No external signal is needed for this, just click Measure, wait a few seconds and then click Save Defaults RX filter calibration is now completed and the RX Measurements window can be closed by clicking Close