Handset Assembly Instructions

NOTE: WEAR GLOVES DURING THE ENTIRE ASSEMBLY PROCESS

B - COVER SUB ASSEMBLY

NOTE: SPEAKER ASSY IS ULTRASONIC _WELDED TO THE B-COVER

Technical Documentation

Mechanical Parts Assembly Instructions

A - COVER PRE ASSEMBLY

Power key (6) to A - cover (ensure, that both coding pins fit into the power key)

Keymat (5) to A - cover (do not touch contact area)

Clean contact pads of keymat module with compressed air in the direction of the arrow

CODING PINS

CODING PINS

PCB SUB ASSEMBLY

• Check the LCD module version (Minna or Dude)

• Check that there is no rest at the PCB larger ca.0.2mm

• Check that all five LCD frame snappers fit accurately into the PCB

• The curly cord (10) plugs into the PCB assy. connector (12) - clamp it into place

• LCD protection foil off

• Clean PCB contact pads and LCD with compressed air

A - cover, ensure it is fitted the right way

• The curly cord to the right side curls upwards

• Clean contact areas compressed air

Mechanical Assembly Instructions

Mechanical Parts Assembly Instructions

Technical Documentation

FINAL ASSEMBLY

• Fit the bottom side of the B - cover (3) to the A -cover (2)

• Press B - cover to A - cover until it snaps home firmly.

3

2 screws (13) trough B - cover into A - cover domes (400 rpm, 30Ncm)

Technical Documentation

• Turn unit over to the keymat side

• 2 screws (13) trough A - cover into B - cover domes

• Verify that A - and B - cover are properly closed by checking that the gap between them is constant all arround the Handset

• Clean window with compressed air

• Pull window adhesive protection foil off the A - cover and ensure, that the adhesive foil does not lift at the finger lift side.

• Press the window down till it clips home

• Press down the window to ensure fixation to B -cover

• Attach protection foil to mounted window

Mechanical Parts Assembly Instructions

NME-3_PAMS

Mechanical Parts Assembly Instructions Technical Documentation

Fit SIM - door (4) to the B - cover (till it firmly snap) Place type label to B - cover

Pull OEM - logo (7) from the roll and stick it to the A - cover

Ensure that the logo fits completely in the recess area

Pack Handset into a plastic bag and bulk package

Nokia 6090 Parts List

Technical Documentation

Mechanical Parts Assembly Instructions

Was this article helpful?

+4 -1
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment