AGC strategy

AGC-amplifier is used to maintain output level of the receiver in certain range. AGC has to be set before each received burst, to do this pre-monitoring is used to give an estimate ofthe signal level.

There is 50 dB accurate gain control (10 dB steps) and one larger step (—30 dB) in LNA. LNA AGC step size depends on channel with some amount.

RSSI must be measured accurately on range -48...-110 dBm. At levels higher than -48 dBm the RX level reported by the MS to the base station is always 63.

Production calibration is done with two RF-levels, the LNA gain step is not calibrated.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment